It might seem to be challenging to install a toilet tank, but it is much easier than that but with the right tools and guidance. Irrespective of the nature of replacement, you need some basic knowledge about the process to efficiently commence it.
A properly installed toilet tank ensures smooth flushing and prevents leaks. Therefore, this guide explains the process in the simplest way to save you from costly plumbing repairs in the future.
Pre-requisites of Toilet Tank Installation
Before installing a toilet tank, a few essentials need to be carried out to effectively commence the process. Tools and materials stand out among the most important things required for a smooth process. Let’s have a look at the requirements of armory for this task.
Tools and Materials Needed
Before starting the installation gather the necessary tools and materials to streamline the task, and achieve timely and useful results. Here is a list of the most essential tools and materials required:
- A new toilet tank
- Adjustable wrench
- Screwdriver
- Rubber washers and bolts
- Flexible water supply hose
- Plumber’s tape
- Bucket and sponge
How to Install a Toilet Tank?
Step 1: Turn Off the Water Supply
Before removing the old tank or installing a new one turn off the water supply to the toilet. The shut-off valve is usually located on the wall behind the toilet. Turn it clockwise to stop the flow of water. Flush the toilet to empty the remaining water from the tank. Use a sponge to soak up the residual water left in the tank.
Step 2: Remove the Old Toilet Tank (For Replacement Cases)
If you are replacing an old tank, use an adjustable wrench to loosen the nuts holding it to the toilet bowl. Carefully lift the tank off the bowl and keep it in a safe place. Remove the remaining bolts, rubber washers, and gaskets from the toilet bowl to prepare for the new installation.
Step 3: Install a New Toilet Tank
Carefully install a toilet tank onto the back of the toilet bowl. Align the mounting holes on the bottom of the tank with the relevant holes on the toilet bowl. Afterwards, ensure the tank sits perfectly over the assembly.
Step 4: Secure the Tank with Bolts
Insert the rubber washers and bolts into the mounting holes. Tighten the nuts from underneath using an adjustable wrench. Do not overtighten as this can crack the porcelain. The rubber washers help create a watertight seal and prevent leaks.
Step 5: Connect the Water Supply Line
Attach the flexible water supply hose to the inlet valve. In most cases, you can find this valve at the bottom of the tank. Wrap plumber’s tape around the threads of the connection to ensure a secure fit and prevent leaks. Tighten the connection with a wrench but avoid overtightening.
Step 6: Turn On the Water Supply
Slowly turn the shut-off valve on to enable the water flow. Allow the tank to fill up and check for any leaks around the connections. If you notice any leaks, slightly tighten the nuts and connections.
Step 7: Test the Toilet
When the tank is full flush the toilet to ensure everything is working properly. Check for the leaks at the base of the tank the water supply connection and the bolts. If you think an adjustment is required, you can adjust the tank’s position slightly.
Step 8: Final Checks
Inspect the entire setup to make sure there are no water leaks. Moreover, wipe down the excess water and ensure the tank is stable. If the toilet flushes smoothly without issues, your installation is complete. If there are complications or leaks that you are unable to prevent, hire LS Plumber Services Singapore for toilet flush tank leakage, shower leak repair, and kitchen sink installation and replacement services.
Conclusion
It is a straightforward process to install a toilet tank in Singapore if done carefully and correctly. By following these steps, you can ensure a secure and leak-free installation. Proper maintenance and regular checks will keep your toilet functioning efficiently for years. If you encounter any major issues immediately hire a professional plumbing assistant to avoid further complications.